Troubleshooting - Hoover UH72003 Owner's Manual

5. TrOuBlesHOOTInG

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take
it to a service center prior to continuing use.
warnInG
!
To reduce the risk of personal injury - Unplug before cleaning or servicing.
PrOBleM POssIBle Cause
1. Power cord not firmly plugged
Vacuum won't
into outlet.
run
2. No voltage in wall plug.
3. Blown fuse or tripped breaker.
4. Thermal Protector activated.
1.Rinsable Filter and/ or Filter
Vacuum won't
made with HEPA media is dirty.
pick up
or
2. Dirt cup full and/ or clogged.
Low suction
3. Broken or worn belt.
4. Brushroll and/ or Hose
clogged.
5. Carpet height setting is
incorrect.
1. Dirt cup full.
Dust escaping
from vacuum
2. Dirt cup not installed correctly.
3. Hose not installed correctly.
4. Rinsable and/ or Filter made
with HEPA media not installed
completely.
1. Carpet height setting is
Vacuum is
incorrect.
difficult to push
or won't move
forward
1. Too much pressure being
Turbo Tool
applied to tool.
brushroll won't
turn
2. Blockage.
3. Low vacuum suction.
1. Belt broken or stretched.
Smoky/burning
smell detected
2. Brushroll is clogged.
!
POssIBle sOluTIOn
1. Plug unit in firmly.
2. Check fuse or breaker in home.
3. Replace fuse/reset breaker in home.
4. Unplug and allow vacuum to cool for 30min.
(This willl reset the thermal protector)
1. Clean Rinsable Filter and or Filter made
with HEPA media.
2. Empty dirt cup.
3. Replace belt.
4. Check Hose. Check Brushroll.
5. Set Carpet Height Adjustment to appropri-
ate setting for carpet being cleaned.
1. Empty dirt cup.
2. Review Dirt Cup removal & replacement.
3. Review Hose installation.
4. Review Filter Removal and Cleaning.
1. Set Carpet Height Adjustment knob to
appropriate setting for carpet being
cleaned.
1. Continue using tool applying light pressure.
2. Remove blockage.
3. Check items under "Vacuum won't pick or
Low suction."
1. Replace brushroll belt.
2. Clear/ remove debris from brushroll.
13 Actual model may vary from images shown.