Remote Access Code; Remote Commands; Using The Answering System - Panasonic KX-TG7861NZ Operating Instructions Manual

Answering System

Remote access code

A 3-digit remote access code must be entered
when operating the answering system
remotely. This code prevents unauthorised
parties from listening to your messages
remotely.
Important:
R In order to operate the answering system
remotely, you must first set a remote
access code.
1
M N (right soft key) #306
2
To turn on remote operation, enter the
desired 3-digit remote access code.
3
MOKN a MeN
Deactivating remote operation
Press * in step 2 on "Remote access code"
page 36.
R The entered remote access code is deleted.

Using the answering system

remotely
1
Dial your phone number from a
touch-tone phone.
2
After the greeting message starts, enter
your remote access code.
3
Follow the voice guidance prompts as
necessary or control the unit using
remote commands (page 36).
4
When finished, hang up.
Voice guidance
During remote operation, the unit's voice
guidance starts and prompts you to press 1
to perform a specific operation, or press 2 to
listen to more available operations.
Note:
R If you do not press any dial keys within 10
seconds after a voice guidance prompt, the
unit disconnects your call.
36
TG7861_62NZ(en)_0121_ver003.pdf

Remote commands

You can press dial keys to access certain
answering system functions without waiting for
the voice guidance to prompt you.
Key
1
2
4
5
6
7
9
0
*4
*5
*6
*#
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
Turning on the answering system
remotely
If the answering system is off, you can turn it
on remotely.
1
Dial your phone number from a
touch-tone phone.
2
Let the phone ring 15 times.
R A long beep is heard.
3
Enter your remote access code within 10
seconds after the long beep.
R The greeting message is played back.
R You can either hang up, or enter your
36
Operation
Repeat message
*1
(during playback)
Skip message
(during playback)
Play new messages
Play all messages
Play greeting message
Record greeting message
Stop recording
Stop playback
Turn answering system off
Erase currently playing message
Erase all messages
Reset to a pre-recorded greeting
message (during greeting
message playback)
End remote operation
(or hang up)
remote access code again and begin
remote operation (page 35).
2013/01/21 9:48:17