Desa HDFB32CA Safety Information And Installation Manual page 11

Unvented (vent-free) universal firebox
Table of Contents

Advertisement

INSTALLATION
Continued
Hood
Figure 14 - Installing Fireplace Hood
INstAllING FIReplAce scReeN
1. Insert each rod through nine rings located
at top of screen (see Figure 15).
2. Insert first rod into rear hole in left side
of firebox. Fasten rod to rear hole near
center of firebox using black shoulder
screw.
3. Insert other rod into front hole on right
side of firebox and fasten using remaining
shoulder screw.
Screw
Front and
Rear Hole
Rod
Ring
Screen
Figure 15 - Installing Fireplace Screen
FIRebox INstAllAtIoN usING
optIoNAl AccessoRy mANtels
This firebox may be installed using the corner
or cabinet mantel with hearth base against
a wall in your home. A perimeter trim kit is
included with the mantel accessories (see
Accessories, page 13). Follow the instructions
included with mantel for installation.
116533-01D
buIlt-IN FIRebox INstAllAtIoN
Built-in installation of this firebox involves
installing firebox into a framed-in enclosure.
This makes the front of firebox flush with wall.
Optional perimeter trim is available (see Ac-
Hood
cessories, page 13) This perimeter trim will
Mounting
extend past sides of firebox approximately
Slot
1/". This will cover rough edges of the wall
opening. If installing a mantel above the fire-
box, you must follow the clearances shown in
Shoulder
Figure 7, page 8. Follow the instructions below
Screw
to install the firebox in this manner.
1. Frame in rough opening. Use dimensions
Screw
shown in Figure 16 for the rough opening.
If installing in a corner, use dimensions
shown in Figure 17 for the rough opening.
The height is 33", which is the same as
the wall opening in Figure 16.
2. Install gas piping to firebox location. This
installation includes an approved flexible
gas line (if allowed by local codes) after
the equipment shutoff valve. The flexible
gas line must be the last item installed on
the gas piping. See Connecting to Gas
Supply in log set owner's manual.
3. Carefully set firebox in front of rough open-
ing with back of firebox inside wall opening.
IMPORTANT: If installing perimeter trim,
see instructions included with perimeter
trim accessory. You must install shoulder
screws now.
Figure 16 - Rough Opening for Installing
Figure 17 - Rough Opening for Installing
www.desatech.com
17
33"
34
/
3
4
in Wall
39
"
/
3
8
34
"
/
3
4
55
"
/
5
8
in Corner
/
"
3
4
"
27
"
/
7
8
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents