Desa HDFB32CA Safety Information And Installation Manual page 10

INSTALLATION
Continued
1. Remove 2 screws holding firebox bottom
in place.
2. Lift and remove firebox bottom (see Figure
9, page 8).
3. Route flexible gas line from equipment
shutoff valve into firebox through side.
notiCe: Most building codes do not
permit concealed gas connections.
a flexible gas line is recommended
to allow accessibility from the fire-
box. the flexible gas supply line
connection to the equipment shut-
off valve should be accessible.
4. Attach gas log heater base to firebox bot-
tom with four screws included with base
(see Installing Heater Base Assembly in
log set owner's manual).
5. Replace firebox bottom and secure with
screws.
AssemblING ANd AttAchING
optIoNAl bRAss tRIm
Note: The instructions below show assem-
bling and attaching brass trim to fireplace.
1. Remove packaging from three pieces of
brass trim.
2. Locate four brass screws, two adjusting
plates with set screws and two shims in
the hardware packet.
3. Align shim under adjusting plate as shown
in Figure 1.
4. Slide one end of adjusting plate/shim in
slot on mitered edge of top brass trim (see
Figure 1).
5. Slide other end of adjusting plate/shim in
slot on mitered edge of side brass trim
(see Figure 1).
6. While firmly holding edges of brass trim
together, tighten both set screws on the
adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for the other
side.
8. Tighten trim hanging screws (#10 x 6.5
shoulder) into holes in cabinets. Place
the assembled trim onto fireplace cabinet.
Align hanging notches on trim with hang-
ing screws on side of fireplace (see Figure
13). Push trim firmly into place, sliding
hanging notches over hanging screws.
10
Side Brass
Trim
Slot
Figure 12 - Assembling Brass Trim
Assembled
Brass Trim
Figure 13 - Attaching Brass Trim to
INstAllING FIReplAce hood
notiCe: the firebox canopy (hood)
must not be modified or replaced
with a canopy (hood) that may be
provided with the unvented decora-
tive room heater.
1. Attach three zinc-colored shoulder screws
to back of hood.
. Insert hood into hood-mounting slots on
firebox.
3. Hold hood in place. Insert two black Phil-
lips screws through bottom of hood and
tighten.
www.desatech.com
Adjusting
Plate
Shim
Mitered Edge
Fireplace
Top Brass Trim
Set
Screws
Slot
Trim
Hanging
Screws
Hanging
Notches
on Trim
116533-01D