Laser Unit - Brother DCP-7080 Service Manual

9.26 Laser Unit

(1) Disconnect the laser unit flat cable from the main PCB ASSY and the laser unit, and
release it from the securing fixtures.
Note:
• After disconnecting flat cables, check that each cable is not damaged at its end or
short-circuited.
• When connecting flat cables, do not insert them at an angle. After insertion, check
that the cables are not at an angle.
(2) Remove the four taptite cup S M3x8 SR screws, and remove the laser unit.
Laser unit flat cable
Main PCB ASSY
Harness routing: Refer to
<Back side>
Fig. 3-83
"3. Left side of the machine",
3-83
Taptite cup S M3x8 SR
Laser unit
"4. Rear side of the machine".
Confidential