Panasonic CF-M34 series Reference Manual page 50

Dealing With Problems
Connecting Peripherals
Your peripheral does not
work (An error occurs while
installing the driver)
Unable to print
The cursor does not move
from mouse operations
The device connected to
the serial port does not
work
E x t e r n a l m o u s e o r
trackball connected to
the external keyboard/
mouse port does not
work
A PC Card does not work
You do not know the
available RAM module
The RAM module has not
been recognized
USB floppy disk drives
do not work as a boot
drive
The address map for
IRQ, I/O port address,
etc. is unclear
A USB device does not
work
You need to use drivers conforming to Windows 2000 Version 5.00.2195. Some
earlier drivers will no longer work.
For more information, ask the manufacturer of the driver in question.
Check the computer-printer connection.
Make sure the printer is on.
Make sure the printer is in the online state.
Make sure paper is in the printer tray and there is no paper jam.
Confirm that [Parallel Port] has not been set to [Disable].
Check your mouse connection, then reboot the computer from the keyboard.
From the keyboard, you may choose to press down on
Check the connection.
Confirm that the device driver for the serial port works. Refer to the reference
manual of the device.
Confirm that two mouse devices are not connected, one through the external key-
board/mouse port and the other through the serial port.
Try setting [Touch Pad] to disable in the Setup Utility.
Confirm that [Serial Port A] (or [Serial Port B]) has not been set to [Disable].
Try setting [Touch Pad] to disable in the Setup Utility, and install the driver of the
external mouse or trackball. (
In some circumstances, if a PS/2 external mouse with a serial interface conversion
function is connected to the port, it may not operate normally. Try connecting it to
the serial port.
Make sure the card is properly inserted.
Confirm that the card conforms to the PC Card Standard.
Note that after a driver is installed, the computer must be rebooted.
Check that the proper port settings have been made.
Read the PC Card's manual. Or, you may need to call the manufacturer of the PC Card.
page 25
Make sure the RAM module has been properly inserted.
Use the RAM module that support the recommended specifications.
Only the Panasonic CF-VFD03U USB floppy disk drive can be used.
Do not connect the floppy disk drive to the USB connector of the port replicator for
this computer.
Make sure [Legacy USB Support] is enable and [Floppy Drive Type] is [CF-
VFDU03(USB)] in the Setup Utility.
Check the address map by going to [View] - [Resources by type] in [Start] - [Settings]
- [Control Panel] - [System] - [Hardware] - [Device Manager].
Restart the computer.
Make sure a driver is installed.
Contact the manufacturer of the product.
(Advanced)
page 8)
, then select [Shut Down].
50