Toyota 2001 Sequoia Owner's Manual page 108

Cover
Type B
102
01_SEQUOIA_U (L/O 0009)
CHILD RESTRAINT SYSTEM
INSTALLATION
Type A—
1. Turn up the cover for lower anchor-
ages of the right side position.
2. Widen the clearance between
seat cushion and seatback a little
and confirm the position of the low-
er anchorages below the tag in the
seat cushion.
3. Latch the hooks of lower straps onto
the anchorages and tighten the lower
straps.
Type B—
1. Turn up the cover for lower anchor-
ages of the right side position.
2. Widen the clearance between
seat cushion and seatback a little
and confirm the position of the low-
er anchorages below the tag in the
seat cushion.
3. Latch the buckles onto the anchor-
ages.
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see "—Using
a top strap" on page 97 in this section.)
2001 SEQUOIA (OM34414U)
For the installation details, refer to the
instruction manual equipped
product.
CAUTION
the
When using the lower anchorages
D
for the child restraint system, be
sure that there are no irregular ob-
jects around the anchorages or that
the seat belt is not caught.
Push and pull the child restraint
D
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.
When using lower anchorages for a
D
child restraint system on the third
the
seats, ensure that the
moved to the rear−most position,
with the seatback close to the child
restraint system.
After securing the child restraint
D
system, never slide or recline the
seat.
with each
seat is