Wood Heater Safety - New Buck Corporation 91 B02F10B82B3D331079A9C

SECTION IV

WOOD HEATER SAFETY

Certain safety hazards are inherent in any wood heater installation. You should be aware of these so that a safe
and proper installation can be made.
1. FAULTY CHIMNEY: An older masonry chimney should be thoroughly checked to be sure there are
no holes or weak spots which could allow sparks or hot gases to escape. If any of these are present, a
positive liner should be installed before heater is installed.
2. HEAT CONDUCTION: Placing combustible materials too close to a heater or chimney can be a fire
hazard.
By keeping these particular hazards in mind as you install and use your room heater you can ensure a safe, reliable
installation.

NOTE: When burning any unit or appliance that combusts fuel for heat, such as coal, oil, wood or
natural and (L.P.) liquid petroleum gas, we highly recommend the use of smoke and carbon
monoxide detectors in your home.
The connector and/or chimney should be inspected at least once a month during heating season to determine if a
creosote buildup has occurred. Any buildup of soot should be removed to prevent risk of a chimney fire. To
remove chimney or chimney connector, remove screws and/or fasteners. Remove pipe and clean with a steel wire
brush. Replace chimney or chimney connector and replace screws and/or fasteners.
CAUTION: NEVER use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid or similar
liquids to start or "freshen up" a fire in the heater. Keep all such liquids well away from the stove when it is in
use. All fluids of this type give off volatile fumes and can and WILL EXPLODE!! Don't take a chance with the
safety of your home and family.
WARNING: Hot while in operation. Keep children, clothing and furniture away from stove. Contact may cause
skin burns.
HELPFUL HINTS
CURING THE PAINT ON YOUR HEATER: During the first several firings, burn small fires to cure paint and
to prevent damage to the finish. It is a good idea to flip the toggle switch to "Manual" position during these first
firings so the blower will run continuously. This will allow paint to cure at a slower rate and creates a better
overall finish.
CAUTION: Never remove ashes from your heater with the blower running.
TIPS ON FIRE BURNING
GREEN WOOD vs. NATURAL SEASONED HARD WOOD-Green wood has a high moisture content and
therefore requires a hotter ignition temperature. Seasoned wood- cut at least one year before use allows for
a quicker, prolonged burn and more complete combustion.
SPLIT WOOD vs. ROUND WOOD- Split wood burns easier and more rapidly, whether it's seasoned or
green. If used after starting a fire, it should be packed tightly to achieve a longer burn.
Round wood burns longer, but requires more effort to start. Inserting a round piece over a bed of red coals
with damper and drafts open will help it catch fire. Round wood should be used to accomplish an all-night
burn.
Page 19
Page 20