Wireless Cylinder Thermostat (Cs92) - Honeywell Evohome Installation Manual

Wireless Cylinder Thermostat (CS92)

Position the sensor from one quarter to a
third of the way up the cylinder.
1
80MM
45MM
evohome Installation Guide
If you're fitting a Wireless Cylinder
Thermostat (CS92)
You will need to install the CS92 Transceiver and only
one of the two sensors (CS92 Strap-on Sensor or
CS92 Insertion Sensor).
To fit the CS92 Strap-on Sensor
Cut away a section of cylinder insulation
1
slightly larger than the sensor unit
Clean the exposed cylinder surface
2
Place the sensor on the cylinder surface
3
and secure it using the fixing strap – cut
the strap to size if it's too long
Install the CS92 Transceiver in a suitable location
4
close enough for the cable from the sensor to reach
Connect the cable from the sensor
5
to the CS92 Transceiver
3
1/4 – 1/3
TOTAL
HEIGHT
MINIMUM
30CM
Wire to CS92 Transceiver
5
A x B y C
A x B y C
5