evohome Installation Guide
Digital Room Thermostat (DTS92)
Put the Room Thermostat into standby mode
1
Press up and down together for 3 seconds
2
Press down once, the display should say CONT
3
Press down for 3 seconds, the display should say TEST
4
Press down for 3 seconds, the display should say SS
5
The evohome Controller will display the signal
strength (poor to excellent) and the Room Thermostat
will display a signal strength rating from 1 (poor) to 5
(excellent) – 0 means the Room Thermostat has not
received a test signal from the evohome Controller.
To exit test mode, press off on Room Thermostat for 5
6
seconds. It will exit automatically after 10 minutes.
1
2
PRESS
AND HOLD
2 SEC
PRESS
AND HOLD
3 SEC
33