Honeywell Evohome Installation Manual page 28

26
Underfloor Heating Controller (HCE80 or HCC80) continued
!
There are two versions
of HCE80/HCC80,
newer versions have a
simplified single stage
bind process while older
versions have a two
stage bind process.
Note the colour of the
flashing zone light
(GREEN or RED) and
follow the instructions for
that version. Put a tick
next to the version for
future reference.
Step 3: Power up and bind devices
Then on the underfloor controller
Press and hold the bind button
1
light turns solid YELLOW and the zone number
light flashes (either GREEN or RED).
Follow the instructions below depending on which colour the
zone number light is flashing:
If the zone light is flashing GREEN (single stage bind):
On the evohome Controller, press the green bind button
2
When the zone light turns solid YELLOW the
3
binding is successful for the zone
Press forward on the evohome Controller
4
to complete the binding for this zone
If you are binding more zones repeat the process from
the sensor binding step on the previous page, then press
the bind button
Controller - The GREEN light will flash on the next zone.
If the zone light is flashing RED (two stage bind):
On the evohome Controller, press the green bind button
2
When the message is received the
3
zone light will turn solid RED
Press the back arrow on the evohome Controller
4
Press the bind button
5
Controller – the zone light should flash GREEN
On the evohome Controller, press the green bind button
6
When the zone light turns solid GREEN the
7
binding is successful for the zone
Press forward on the evohome Controller
8
to complete the binding for this zone
If you are binding more zones repeat the process from
the sensor binding step on the previous page, then press
the bind button
Controller - The RED light will flash on the next zone.
until the bind
twice on the Underfloor Heating
on the Underfloor Heating
once on the Underfloor Heating