Table of Contents
Advertisement
Installation Overview
You are connecting to a standard definition TV – Connect the
connector using an S-video cable, or connect the composite
connector using an RCA phono cable. If the TV only has a coaxial RF
input, connect it to the DCT3080
Determine if you are connecting the audio to a home theater receiver or
directly to the TV:
If the receiver or TV has an SPDIF input, use the optical spdif or
coaxial spdif outputs.
Otherwise, use the baseband left and right audio out outputs.
1
Locate the cabling diagram(s) that best match the subscriber
configuration.
Connect the audio and video cables in a manner matching that
diagram.
Determine if you are connecting to a data device (see "Data
Device Connections" in this section). For installation details,
refer to instructions included with the data device.
Connect the cable terminal to the coaxial cable wall outlet.
Perform the boot cycle, including the download to the terminal,
as described in "Boot Cycle" in this section.
2
Perform the operational check for the remote control.
Optimize the video settings. See "Optimizing Video Settings" in
this section.
Verify that the appropriate configuration information has been
downloaded using the addressable controller, such as the DAC 6000.
DCT3080 Installation Manual
connector.
RF OUT
21
-
S
VIDEO
VIDEO
Advertisement
Table of Contents
