Toyota 2007 FJ Cruiser Owner's Manual page 268

06 08.24
TS40004
When connecting the jack handle ex-
tension(s) and jack handle end, use
the jack handle to tighten the square
head bolt. Make sure that the bolt fits
into the depression on the joint.
When connecting the jack handle ex-
tension with the jack handle, tighten
the round head bolt by hand.
NOTICE
Tighten the square head bolt
securely. Otherwise, the exten-
sion may come off and it may
damage the paint or vehicle
body.
258
—Raising your vehicle
LS40037
Front of
vehicle
6. After making sure that no one
is in the vehicle, as the jack
touches the vehicle and begins
to fit, double−check that it is
properly positioned.
Rear side only—
When positioning the jack under the
rear axle housing, make sure the
groove on the top of the jack fits with
the rear axle housing.
2007 FJ CRUISER from Oct. '06Prod. (OM35873U)
TS40010
7. After making sure that no one
is in the vehicle, raise it high
enough so that the spare tire
can be installed.
Remember you will need more ground
clearance when putting on the spare
tire than when removing the flat tire.
To raise the vehicle, insert the jack
handle end into the jack (it is a loose
fit) and turn it clockwise with the han-
dle.