Toyota 2007 FJ Cruiser Owner's Manual page 155

1 2 3 4 5 6 (Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station. (See "TUNE·FILE" or
"SEEK/TRACK".) Push and hold down the
button until you hear a beep—this will set
the station to the button. The preset but-
ton number will appear on the display.
To recall a preset station: Push the button
for the station you want. The preset but-
ton number and station frequency will ap-
pear on the display.
These systems can store one AM and two
FM stations for each button. (The display
will show "AM", "FM1" or "FM2" when you
push "AM", "FM1" or "FM2" button.)
(Eject button)
Push the compact disc eject button to
eject a compact disc.
(Reverse/Fast−forward button)
Push and hold " " (preset button 6) or
" " (preset button 5) to fast−forward or
reverse within a compact disc. When you
release the button, the compact disc play-
er will resume playing.
AM
Push the "AM" button to turn on the radio
and select the AM band. "AM" will appear
on the display.
AUDIO CONT (Tone and sound balance
controls)
Each time you push the "AUDIO CONT"
knob, the mode changes. To adjust the
tone and balance, turn the knob.
BAS: Adjusts low−pitched tones. The dis-
play ranges from −5 to 5.
TRE: Adjusts high−pitched tones. The dis-
play ranges from −5 to 5.
FAD: Adjusts the sound balance between
the front and rear speakers. The display
ranges from F7 to R7.
BAL: Adjusts the sound balance between
the right and left speakers. The display
ranges from L7 to R7.
2007 FJ CRUISER from Oct. '06Prod. (OM35873U)
DISC·AUX (Compact disc)
Push the "DISC·AUX" button to play a
compact disc.
When the audio system is set to compact
disc operation, the display shows
track number currently being played.
To switch between CD and AUX (external
device) modes, press the "DISC·AUX"
button. The AUX mode is only available
when AUX adapter is connected to the
system. When you push the "DISC·AUX"
button, "AUX" will appear on the display.
Error messages
If the player malfunctions, your audio sys-
tem will display following error messages.
"WAIT": The compact disc player unit
may be too hot. Allow the player to cool
down.
"ERROR 1": The disc may be dirty, dam-
aged or inserted incorrectly
down). Clean the disc and re−insert it.
"NO DISC": The compact disc changer of
the separate unit is empty. Insert a disc.
"ERROR 3": There is a problem inside
the system. Eject the disc or magazine.
Set the disc or magazine again.
"ERROR 4": Over−current. Ask
Toyota dealer to inspect.
the
(up−side
your
145