Traction Control System - Toyota 2007 FJ Cruiser Owner's Manual

06 08.24
(c) Shifting procedure
SHIFTING BETWEEN "H2" AND "H4"
To shift from "H2" to "H4", reduce your
speed to less than 80 km/h (50 mph) and
move the front drive control lever.
If you have trouble shifting in cold weath-
er, reduce your speed or stop the vehicle
and reshift.
CAUTION
Never move the front drive control
lever if wheels are slipping. Stop the
slipping or spinning before shifting.
To shift from "H4" to "H2", simply move
the front drive control lever.
This can be done at any vehicle speed.
If the indicator light does not go off when
you shift the transfer into "H2", drive
straight ahead while accelerating or decel-
erating, or drive in reverse.
SHIFTING BETWEEN "H4" AND "L4"
Stop the vehicle, put the transmission into
"N" and move the front drive control lever.

Traction control system

The traction control system automatical-
ly helps prevent the spinning of rear
wheels (two−wheel drive models) or 4
wheels (four−wheel drive models) when
the vehicle is started or accelerated on
slippery road surfaces.
When the ignition key is turned to "ON",
the system automatically turns on.
CAUTION
Under certain slippery road condi-
tions, full traction of the vehicle and
power to the rear wheels (two−wheel
drive models) or 4 wheels (four−wheel
drive models) cannot be maintained,
even though the traction control sys-
tem is in operation. Do not drive the
vehicle under any speed or maneuver-
ing conditions which may cause the
vehicle to lose traction control. In si-
tuations where the road surface is
covered with ice or snow, your ve-
hicle should be fitted with snow tires
or tire chains. Always drive at an ap-
propriate and cautious speed for the
present road conditions.
2007 FJ CRUISER from Oct. '06Prod. (OM35873U)
TS17007
NORMAL DRIVING MODE
Leave the system on during the ordi-
nary driving so that it can operate
when needed.
You may hear a sound in the engine
compartment for a few seconds when the
engine is started or just after the vehicle
begins to move. This means that the trac-
tion control system is in the self−check
mode, but does not indicate a malfunction.
When the traction control system is oper-
ating, the following conditions occur:
123