Table of Contents
Advertisement
Solution
Use
ifconfig -a
7)
Problem
How to I unload the Driver?
Solution
There are 2 ways to unload the driver:
rmmod sm_drv_pc16
Just unplug the device, it automatically unloads the driver
In both cases, "<< Conexant STUN : PC16 >>... Unloaded (2.0.0.0-0xxLD" message is
displayed.
8)
Problem
When I issue make command, it throws me message
" CardManager Configuration file doesn't have information about the Conexant Stun
PCCARD Device; Please go thru the README file for steps to add information into /
etc/pcmcia/config" ?
Solution
This message comes when you have not configured the below file properly.
/etc/pcmcia/config
Please refer steps to add cardmgr config in
9)
Problem
What is the use of setoid and getoid commands?
Solution
They are used to set/get Symbol specific OIDs to/from the device respectively. For a
complete list of OIDs, refer the
10) Problem
When I try to load the driver, it says Unresolved symbols
register_pccard_driver,unregister_pccard etc. and fails to load?
Solution
This happens when pcmcia hotplug support is not enabled in the kernel. You can verify
the same by running
service pcmcia restart
If it fails, then you need to recompile the kernel with HotPLUG (CONFIG_HOTPLUG=y)
support.
.This provides the ethX information
Configuring the Linux system for
LA-51XX API Programmer's Reference Guide.
1-7
Troubleshooting
LA-51XX.
Advertisement
Table of Contents
