Base Reset; Registration; Register A Handset - Motorola B801 User Manual

NOTE
If, in the future, your telephone service provider requires you
to dial 10 digits to make a local call (area code + phone
number), re-program the home area code by following the
steps above. With the home area code displayed, press and
/
hold to remove the contents. The home area code will
now be restored to its default setting of
6.3.4

Base reset

P
Press when in idle mode to enter the feature menu.
,
>SETUP BS
1. Press to scroll to
P ,
2. Press and to select
P
RESET?
3. Press and will be prompted.
P
4. Press to confirm and reset all the personalized
settings of base to default.

Registration

_ _ _
.
.
>RESET
.
7. Registration
Your new telephone system can accommodate up to 5
handsets. You can add new handsets to your telephone
system, but each device must be registered with the
telephone base before use.
7.1

Register a handset

Handsets purchased separately need to be registered to the
telephone base before use. When first purchased, all
expansion handsets will show
The new handset(s) may need to be charged for five minutes
before registering to the telephone base.
1. Place the unregistered handset into the telephone base.
PRESS FIND FOR 4 SEC ON BASE
If
handset screen after a few seconds, remove the
handset and place it in the telephone base again.
2. On the telephone base, press and hold
four seconds (until the red IN USE light on the telephone
base turns on and flashes slowly) and then release the
button. The handset will show
NOT REGISTERED
on the screen.
does not appear on the
a
for about
PLEASE WAIT...
and it will
41