Technical Information - IKEA LAGAN User Manual

ENGLISH
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
The washing and drying results are not satisfactory
Problem
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry wa-
ter drops on glasses and
dishes.
The dishes are wet.
Refer to "Hints and tips" for
other possible causes.

Technical information

Product denomination
Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
Power consumption
1) Refer to the rating plate for other values.
2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water sup-
ply to decrease energy consumption.
• The release quantity of rinse aid is too much. Adjust
the rinse aid selector to a lower position.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient. Ad-
just the rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
• The programme does not have a drying phase or has
a drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
Fully integrated dishwasher
Width / height / depth
(mm)
Voltage (V)
1)
Frequency (Hz)
Min. / max. bar (MPa)
Cold water or hot water
Place settings
Left-on mode (W)
Off-mode (W)
For alarm codes not described in the table,
contact an Authorised Service Centre.
Possible solution
596 / 818-898 / 555
220 - 240
50
0.5 (0.05) / 8 (0.8)
max 60 °C
2)
12
5.0
0.50
16