Leaf Collect; Remove The Plug From The Socket; Power Supply; Electrical Safety - Bosch Rotak 37 Ergoflex Original Instructions Manual

OBJ_BUCH-2011-004.book Page 4 Tuesday, September 30, 2014 8:26 AM
4 | English

Leaf Collect

The leaf collect blade has been de-
signed to allow you to pick up autumn
leaves from your lawn. In order for this
functionality to work within optimal pa-
rameters, please note the following:
– only collect leaves with the machine
set at 70 mm cutting hight
– collect leaves from your lawn only
– before collecting leaves inspect the
area where the machine is to be used
and keep people, pets, glass struc-
tures and cars away from use

Remove the plug from the socket:

– Whenever you leave the machine.
– Before clearing a blockage,
– Before checking, cleaning or working
on the machine,
– After striking a foreign object. Inspect
the machine for damage and make re-
pairs as necessary,
– If the machine starts to vibrate abnor-
mally (check immediately).

Power supply

 The voltage indicated on the rating
plate must correspond to the volt-
age of the power source.
 We recommend that this equipment
is only connected into a socket
which is protected by a circuit-
breaker that would be actuated by a
30 mA residual current.
 Only use or replace power supply
cables for this unit which corre-
spond to the types indicated by the
manufacturer. See the operating in-
structions for the order no. and
types.
F 016 L81 157 | (30.9.14)
 Never touch the mains plug with wet
hands.
 Do not run over, crush or pull the
power supply cable or extension
lead, otherwise it may be damaged.
Protect the cable from heat, oil and
sharp edges.
 The extension lead must have a
cross section in accordance with the
operating instructions and be pro-
tected against splashed water. The
connection must not be in water.
 Always wear gardening gloves when
handling or working near the sharp
blades.

Electrical Safety

 Warning! Switch off, remove plug
from mains before adjusting,
cleaning or if cable is cut, dam-
aged or entangled.
 The blades continue to rotate for a
few seconds after the machine is
switched off.
 Caution – do not touch the rotat-
ing blade.
Your machine is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use ap-
proved extension cables. Contact your
Bosch Service Centre for details.
Extension cords/leads should only be
used if they comply with H05VV-F,
H05RN-F types or IEC type design
(60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
Bosch Power Tools