Step 6: Upgrade Firmware To Latest Version (If Available); Step 7: Verify Camera Image; Step 8: Set The Time; Default System Password & Port Numbers - Lorex LNR110 Series Instruction Manual

6 Basic Setup (LNR110 Series)
At startup, the system performs a basic system check and runs an initial loading sequence.
After a few moments, the system loads a live display view.

6.6 Step 6: Upgrade Firmware to Latest Version (if Available)

If a firmware upgrade is available, you will be asked to install it once the system starts up.
It is required to upgrade your system firmware and client software or mobile apps to the lat-
est version to enable remote connection to the system.
If a firmware upgrade is available:
1. After startup, a notification will appear asking you to upgrade the firmware. Click OK to
upgrade.
2. Enter the system user name (default: admin) and password (default: 000000) and
click OK. Wait for the firmware update to complete. The system will restart once the
firmware has been upgraded.
WARNING
DO NOT POWER OFF THE SYSTEM OR DISCONNECT THE POWER CABLE DURING FIRM-
WARE INSTALLATION

6.7 Step 7: Verify Camera Image

• Power on the cameras, and then verify the camera video quality before mounting the
cameras to a permanent location.
• Mount the cameras under a sheltered location. Always verify the outdoor rating of your
camera before installing it in a permanent location.

6.8 Step 8: Set the Time

• Set the system time and date for accurate video time stamps. Videos with inaccurate
times may not be valid as surveillance evidence.
• For details on setting the system time, see 8.8 Setting The Time, page 23.
6.9 Default System Password & Port Numbers
CAUTION
By default, the system user name is admin and the password is 000000. It is essential that you create
your own password. For details, see 12 Managing Passwords and User Accounts, page 40.
#LX400070; r. 1.0/27147/27147; en-US
11