Majestic 33BDVT Installation Instructions And Homeowner's Manual page 22

BDVT Series Direct Vent Gas Fireplace
39BDVT
Refer to Figure 38.
1. Remove the top louvre assembly.
2. Remove the window frame assembly.
3. Fit the rear left log (BC10) onto the left side of the
rear log support. Ensure the log's bottom holes are
located on the two studs of the support.
4. Fit the rear front and right log (BC13) onto the right
side of the rear log support. Ensure the log's bottom
holes are located on the two studs of the support
and the front end of this log will be set onto the right
side of the burner housing assembly.
5. Fit front left log (BC11) onto the left support bracket
over the burner housing assembly. Ensure the log's
bottom holes are located on the two studs of the
bracket.
6. Place the top right log (BC12) on top of the rear and
front right log by resting the pre-cut rectangular hole
under the end of this log located over the
rectangular knob on the rear and front right log.
(Fig. 38)
7. Scatter the ember material over the front area of the
burner housing assembly. (Fig. 38) Do not pack this
material tightly, separate it when unpacked and
keep it in a loose condition.
8. Scatter the lava rock material around the firebox
base.
Do not place any of the lava rock
material on the burner housing
assembly.
33BDVT
BC10
Embers
BC11
LG269
Fig. 38 39BDVT log placement.
22
Refer to Figure 39.
1. Remove the top louvre assembly.
2. Remove the window frame assembly.
3. Fit the rear left log (BD11) onto the rear log support.
Ensure the back of the log is flat against the rear
wall of the support.
4. Fit the front left log (BD12) onto the left support
bracket over the burner housing assembly. Ensure
the log's bottom holes are located onto the two
studs of the bracket.
5. Place the top center log (BD13) in place with the
front part of the log sitting against the back wall of
the deflector. Make sure the right front end of the
log is touching against the bend back of the
deflector. Also the back end of this log will be
reclined onto the rear log.
6. Place the front right log (BD14) in place with the
front part of the log sitting against the back wall of
the deflector. Make sure the right front end of the
log is touching against the bend back of the
deflector. Also the back end of this log will be
reclined onto the rear log.
7. Scatter the ember material over the front area of the
burner housing assembly. (Fig. 39) Do not pack this
material tightly, separate it when unpacked and
keep it in a loose condition.
8. Scatter the lava rock material around the firebox
base.
BC13
43BDVT
BC12
LG270
Fig. 39 43BDVT log placement.
43BDVT
Do not place any of the lava rock material
on the burner housing assembly.
BD13
BD12
Embers
BD11
BD14
10003358