Remote Unit Assembly - Oregon Scientific WMR200 User Manual

REMOTE UNIT ASSEMBLY

1. Insert the cone-shaped end into the pole.
sing screws, fi it fir ly into place
3. Insert the versatile plastic base into the pole. Align the holes of the pole with the
holes of the plastic base.
Secure the plastic base by inserting the screw and screwing it tightly into the
holes of the plastic base and pole.
a er pole cone end down into the ground at the desired spot until ersatile
plastic base is level with the ground.
TIP Place a block of wood between the pole and the ha
to the pole.
sse ble iddle pole on top of the botto
sing two screws, fi it fir ly into place
sse ble top pole on top of the
sing two screws, fi it fir ly into place
10 Slide the ertical attach ent bracket on top of the top pole
11 sing two screws, fi it fir ly into place
To mount the temperature / humidity sensor:
12. Slide outdoor sensor onto ertical attach ent bracket
IMPORTANT The sensor
should be positioned in an open
area away fro trees or other
obstructions.
er to pre ent da age
one
iddle one
13. Slide the solar panel connector into place on the opposite side of the bracket. Slot
the solar panel in place.
14 d ust the solar panel Once facing desired direction, use screw to fi in place
15. Loosen the wing bolt and adjust the angle. Tighten wing bolt to secure solar panel
at desired angle.
NOTE For best results, direct solar panel as follows:
Solar panel facing:
North
South
To mount the wind sensor:
16 nsert the wind ane into the attach ent bracket
17 Screw alu inu pole fir ly into place
IMPORTANT For best results, point the wind vane North.
18. e o e outdoor sensor fro
19. Replace sensor into the casing.
20. Plug the other solar panel cable into the socket on the wind vane.
This will pro ide the sensors with an additional power supply
NOTE There are slots to insert the solar power cables for convenient storage. There
are also fasteners to help tighten the cables.
NOTE The solar panel is an energy sa ing feature, which is an en iron entally
friendly way to pro ide additional power to the sensors and prolongs battery life
owe er, it cannot replace battery power entirely Sensors can operate entirely on
battery power
Securing the assembled remote unit:
21. Insert the 2 rectangular base legs through the holes of the versatile base and
ha er down
5
if you reside in the:
Southern e isphere
orthern e isphere
casing Plug one solar panel cable into the socket