Connecting The Power Cord - Winnebago Suncruiser 33V Operator's Manual

SECTION 6
ELECTRICAL

Connecting the Power Cord

To connect to an external source, remove the
cord from the utility compartment and plug it into
a suitable power outlet to provide external power
to the coach and converter/charger system.
Your coach may be equipped with either a
standard 30-amp system or an optional 50-amp
system.
NOTE: Some parks do not have 50-amp service
available, so you will need to connect to
a standard 30-amp service pole using an
adapter.
If your coach is equipped with standard
30-amp system, you cannot connect to a
50-amp service. Do not use adapters to
connect 30-amp systems to a 50-amp
service or you may cause an overload on
electrical system components.
50 Amp.
Power Receptacle
A flip down hatch in the compartment floor
lets you route the power cord through a passage
in the bottom of the compartment so you can
shut the compartment door while the power cord
is connected.
6-2
30 Amp Receptacle
1. Swivel the hatch retainers aside and lower the
hatch.
2. Swivel the cord notch cover aside.
3. Route the cord through the notch and close the
hatch.
Park Fuses or Breakers
Most campgrounds are equipped with a fuse
or circuit breaker at the receptacle. This protects
the park's wiring, as well as the power cord on
your vehicle, from electrical damage. If electrical
power fails, contact the park attendants and have
them check the fuse or breaker for your supply
receptacle.
After disconnecting the power cord, neatly
replace it in the utility compartment.