Table of Contents
Advertisement
SECTION 6 -
ELECTRICAL
be used is designed to mate with the prongs of the
power cord plug, the electrical connection can be
expected to carry rated load.
Connecting the Power Cord
To connect to an external source, remove the
cord from the utility compartment and plug it into
a suitable power outlet to provide external power
to the coach and converter/charger system.
Your coach may be equipped with either a
standard 30-amp system or an optional 50-amp
system.
NOTE: Some parks do not have 50-amp service
available, so you will need to connect to
a standard 30-amp service pole using an
adapter.
If your coach is equipped with standard
30-amp system, you cannot connect to a
50-amp service. Do not use adapters to
connect 30-amp systems to a 50-amp
service or you may cause an overload on
electrical system components.
50 Amp.
Power Receptacle
A rotating hatch in the compartment floor lets
you route the shoreline cord through a passage in
the bottom of the compartment so you can shut
the compartment door while the shoreline is
connected.
7. Flip the retainer in the center of the cover
straight up.
6-2
30 Amp Receptacle
8. Rotate the cover to the largest hole to pass the
cord end through.
9. Then rotate to the smaller opening to enclose
the cord.
NOTE: Always keep service access passage
closed while utility connection is not in
use.
The three-prong power cord is designed to
ground the electrical system through the
receptacle. It is also designed to carry the
amperage output of most campground outlets. If
the electrical receptacle to be used is designed to
Advertisement
Table of Contents
