Motorola TimePort Portable Cell Phone User Manual page 127

Troubleshooting
Q. I tried to place a call but received an alternating
high/low tone. What does this mean?
A. This sound means your call did not connect to the network. Most likely, you
dialed the number too soon after turning the phone ON. Wait until you see your
phone's idle display (in the main display either
Provider, or your programmable banner) before placing a call.
An alternating tone may also indicate that your phone's signal is blocked. Make
sure the antenna is fully extended and move clear of any obstructions, like
bridges, parking garages, tall buildings, etc.
Q. Whenever I turn the phone ON, the display says:
. What does this mean and why am I not able to charge
B B B B a a a a t t t t t t t t e e e e r r r r y y y y
the battery?
A. Your wireless phone uses the Motorola Expert Performance (E•P) Charging
System. The E•P system enables the built-in charger to communicate with
attached batteries and tailor its charging cycle to optimize performance.
If you see
Invalid Battery
charger is not able to communicate with the battery and cannot charge it. You
could see this message for several reasons. The most likely one is that the battery
is not a Motorola Original ™ and it does not have the appropriate E•P
technology. We recommend that you use only Motorola original batteries and
accessories and that you store your batteries in their protective covers when not
in use.
Q. My phone started beeping, and the display says:
. What happened?
U U U U n n n n a a a a n n n n s s s s w w w w e e e e r r r r e e e e d d d d
A. Someone tried to call you while you were in an area where the signal was
Ç
weak. Press to clear your display, extend your phone's antenna, and avoid
obstructions like tunnels, parking garages and tall buildings whenever possible.
, the name of your Service
Ready
I I I I n n n n v v v v a a a a l l l l i i i i d d d d
when you power up the phone, the built-in
1 1 1 1 C C C C a a a a l l l l l l l l
127