Remington HyperFlex XR1330 Use And Care Manual page 9

Weekly:
1. Perform the daily cleaning steps 1 and 2.
2. Remove the hair pocket from the head & cutter assembly. (Diagram L) Place the
body of the shaver aside.
3. Hold the cutter assembly so that the blue cutter is facing towards you. Slide the
inner cutter carrier away from the blue cutter to release it from the assembly.
(Diagram M)
4. Lift and remove the inner cutter carrier away from the cutters.
5. Remove the cutters. (Diagram N)
6. Thoroughly rinse away any debris from inner and outer cutters with warm water.
7. Replace the inner cutters. (Diagram O) The inner and outer cutters are colour
coded (orange, blue and black) to ensure each cutter is returned to its original
and most effective position on the cutter assembly.
8. Hold the inner cutter carrier with the raised center section facing upwards.
Place it over the cutters so that the centre mouth opening is facing the blue
cutter. Slide the cutter carrier towards the blue cutter until the locking tab locks
under the centre triangle. (Diagram P)
9. Lubricate each cutter with Remington Shaver Saver (SP4).
10. Gently reattach the hair pocket to the neck assembly until it lock in place on
all three sides. The hair pocket may be reattached in any configuration.
(Diagram Q)
** Pop Up Trimmer: Lubricate teeth with oil every six months
L L
P
M
Q
N
9
O