Table of Contents
Advertisement
43
the correct temperature and supplies tasteless
hot water to be used for tea, soup, etc.
Press the hot water key, the display will
show:
"HOT WATER
During hot water dispensing, only the
programmed amount is dispensed if the
corresponding programming is enabled.
On the contrary, dispensing should be
stopped by pressing again the selection key
when the desired amount is reached.
To program the hot water amount, it is
necessary to keep the corresponding selection
key pressed till the desired amount is reached.
Attention: hot water can only be
programmed if the corresponding
programming function is enabled
(see page 38).
During the programming phase, the
following message will be displayed:
"HOT WATER
"PROGR. QUANTITY "
31
Place a glass or cup under the steam/hot
water spout (7), then press the hot water
selection key. Hot water will be automatically
dispensed.
Steam
To heat milk or other drinks.
Always clean the spout with a damp cloth
soon after the use; otherwise, it might be
difficult to remove milk residues.
0339.951 ed. 01 10/00 ING (UL)
8
INCORPORATED SAFETY DEVICES
Turn the steam knob (9), the display will show:
"STEAM
Direct steam/hot water spout (7) on cup
holder grill (3) and slightly open knob (9),
"
turning it counterclockwise.
Wait until the remaining water has flown out of
the spout. Then, move the spout outwards and
plunge it deeply into the fluid to be heated.
32
Slowly open the steam/hot water knob and
heat the fluid, with a circular movement from
the bottom to the top.
When the fluid has reached the desired
temperature, close the knob and immediately
clean the spout with a damp cloth.
Attention: the spout is hot, it may cause
burns!
Cappuccino froth
Fill a cup 1/3 with cold fresh milk, then immerse
the steam/hot water dispensing tube (7) just below
"
the milk surface. Move the cup with a circular
movement to form a thick froth. Then immerse the
dispensing tube deep into the milk to heat it.
USER MAINTENANCE
INSTRUCTIONS
Incorporated safety devices
Automatic off
Should the service door be open, the
machine automatically switches off and its
operation is thus prevented. If the central
unit is not mounted, it is possible to dispense
water/steam but not coffee steam.
44
Electronic grinding time control
"
As soon as the coffee bean container is empty,
the machine automatically stops after approx.
20 seconds. Fill the container with coffee beans.
The coffee brewing cycle can be restarted.
Electronic pump delivery control
The machine switches off automatically as soon
as the water tank is empty.
Automatic temperature
adjustment
This adjustment controls the correct temperature
for coffee, water, and steam. Coffee brewing is
automatically interrupted should the water
temperature be too high (safety thermostat and
overheating safety device activated).
Antigravel device
Even selected coffees may contain some impurities.
The coffee grinder is fitted with an antigravel
device to avoid any damage. Should gravel end
up into the coffee grinder, you will hear a strong
and characteristic noise. Stop the machine
immediately otherwise the protection system will
stop the coffee grinder after approx. 20 seconds.
Cleaning/Maintenance
Cleaning
To ensure high coffee quality and a longer
working life of the machine, always keep the
machine clean.
11-12-2000, 18:07
CLEANING/MAINTENANCE
Before cleaning the machine, turn off the main
switch and unplug the machine.
Before cleaning the machine, wait until it cools
down.
Do not immerse the machine into water or other
fluids. (It may be damaged!)
Do not wash parts of the machine in the
dishwasher!.
Always handdry all parts of the machine; do not
dry them in the oven or microwave oven!
Water tank / Drip tray / Coffee
grounds container / Coffee dispensing
unit / coffee machine
33
In order to keep the service area and the central
unit (22) clean, it is recommended to empty the
coffee grounds container (1) every day.
The water tank (11), drip tray (2), cup holder grill
(3), and coffee grounds container should be
washed periodically, using a non-abrasive solvent
and drying them carefully.
34
The coffee dispenser (6) may be removed for
cleaning operations. Unloose the screws and rinse
the dispensing tubes thoroughly with hot water.
Hide quick links:
Advertisement
Table of Contents
