Removing The Refrigerator And Cooling Unit; Replacing The Cooling Unit - Norcold 1200 series Service Manual

Replacing the Cooling Unit

Ice maker
water line
NOTE
This procedure supplements the instructions packaged
with 1200 model replacement cooling unit. Follow the
procedure thoroughly to install the cooling unit correctly.
Incorrect installation, adjustments, or modifications will
affect cooling performance.

Removing the Refrigerator and Cooling Unit

Refer to Figure 34 to locate components.
1. Turn refrigerator OFF.
2. Close the LP gas tank valve(s).
3. Disconnect 12 Vdc from RV DC distribution panel.
4. Disconnect DC power supply from power board.
5. Unplug AC power cord from RV AC receptacle.
6. Disconnect the RV LP gas supply line from the
gas valve.
1200XX/120X-IMXX Models
Foam
plug
Wire
harness
Power
board
AC
cord
Gas
valve
Figure 34. Cooling unit and components
www.norcold.com/cda
Serial Number Serial Number 700000 700000
NORCOLD NORCOLD Made in USA Made in USA
Water valve
Ice maker and/or dispenser models
a. Disconnect the ice maker AC power cord from the
RV outlet.
b. Close the water supply valve to the ice maker.
c. Disconnect the RV water supply line from the ice
maker/dispenser water valve.
7. Remove rear mounting flange screws.
8. Remove trim pieces.
9. Remove upper and lower mounting bracket screws.
10. Remove any other mounting screws present in the
breaker.
11. Remove the refrigerator from the enclosure.
Refrigerator Service Manual
Condenser
Cable ties
Fans
Absorber
coils
Liquid
heat
exchanger
Drip
cup
Burner
box