Creating An Original Multi Play Setup - Yamaha SY55 Product Manual

Creating an Original
MULTI PLAY Setup
22
In this section we'll go through the steps to create a simple "Jazz Quartet"
MULTI PLAY setup consisting of the following voices:
Channel 1 .........P01 Piano
Channel 2 .........P62 WdBass Duo
Channel 3 .........P40 Vibraphone
Channel 4 .........P63 Drum Set 1
Channels 5 ... 16 ...off
Note: P62 WdBass Duo is actually a split voice with wood bass ranging
from C-2 to E3 and piano on all higher keys up to G8.
1. If it is not already selected, press [MULTI] to select the MULTI PLAY
mode.
2. Use the [INTERNAL], [-1/NO] and [+1/YES] keys to select MULTI PLAY
setup I01.
3. Press [EDIT/COMPARE] to enter the MULTI PLAY EDIT mode.
4. If a display similar to the following is not showing, press the [JOB] key,
then the numeric" [1] key, and finally the [ENTER] key to select it (while
the [PAGE and [PAGE
ward through the jobs in any edit mode, using job numbers is often the
fastest way to access a specific editing job — "REFERENCE" section,
page 52).
This is the display for the MULTI PLAY EDIT mode voice assign-
ment function ("REFERENCE" section, page 108).
5. The and
desired channel (a channel number between CH1 and CH16 will appear in
the upper right-hand comer of the display), and the [DATA ENTRY]
control, [+1/YES] and [-1/NO], keys or numeric and [ENTER] keys are used
to assign the desired voice to the selected channel.
With the cursor at the channel-1 position, make sure the P01 (Piano)
voice is selected.
Move the cursor to the channel-2 position by pressing
voice P62 (WdBass Duo).
Move the cursor to the channel-3 position by pressing
voice P40 (Vibraphone).
Move the cursor to the channel-4 position by pressing
voice P63 (Drum Set 1).
keys can be used to step forward and back-
cursor keys are used to move the cursor to the
, then select
, then select
, then select