Control Explanation - Harman P43 Owners Manual Care And Operation

C. Control Explanation
Power Light
Indicates power to the
control.
Status Light
Will be lit in either stove
or room temp mode
when pointer is not
within off position band
except after normal
shut down. Blinks to
indicate errors listed
below.
Indicates power to
distribution blower.
Indicates power to
combustion blower
Indicates power to the
feed motor.
Indicates igniter is on.
Temp dial
Allows you to adjust the room temperature setting, in
Room Temp Mode, using the outer scale marked in
degrees Fahrenheit. It also allows you to adjust the
constant burn setting, while in Constant burn Mode,
using the inner scale marked from 1 to 7.
9
Dealer Diagnostic Port
For dealer maintenance
only. Requires special DDM
monitor supplied to Harman
Dealers exclusively.
Harman® • P-Series Owner's Manual_R10 • 2014 - ___ • 11/15
Feed limit
Sets the maximum feed
rate
Test
Runs all motors at full
speed for one minute
to check operation.
A f t e r w a r d s
control will simulate
a minimum burn with
the combustion blower
remaining on low.
Igniter switch
Set to appropriate
Start-Up mode.
Distribution Blower
s p e e d a d j u s t m e n t
range.
Mode Selector
Allows you to choose between
Room Temp Mode, Constant burn
Mode, or OFF. Also allows you to
®
vary the distribution blower speed
by turning the knob to the high or
low side of each mode.
t h e
L = low
H = high
3-90-436168c