Sony DVP-PQ2 Service Manual page 8

Connecting
Other
Components
For better pictures
If your TV* has an S VIDEO input jack, connect this player to your TV
using an S VIDEO cord for higher quality images.
* You can also use monitors and projectors.
Connecting to your TV using an S VIDEO cord
Player
S VIDEO cord
To S-VIDEO OUT (not supplied) To S VIDEO input
To AUDIO OUT L/R
VIDEO OUT
White
To audio
(R) input
(L)
S-VIDEO OUT AUDIO OUT
Audio/video cord
DIGITAL OUT(COAXIAL) Red
(supplied)
Connecting headphones/earphones
i (phone) jack and adjust the
Connect headphones or earphones to the
(volume) control.
To i (phone) jack
VIDEO OUT
Headphones/earphones
L
(not supplied)
R
AUDIO OUT
S-VIDEO OUT
DIGITAL OUT(COAXIAL)
For better sound
You can connect this player to an amplifier and speakers to enjoy better
sound. See the relative diagrams below to connect to an amplifier.
– A stereo amplifier: Use a stereo audio cord.
– An AV amplifier with DTS, Dolby Digital, or MPEG audio decoder: Use
a coaxial digital cord*. You can enjoy the DVD's DTS, Dolby Digital, or
MPEG audio sound.
– An AV amplifier with Dolby Surround (Pro Logic) decoder: Use a stereo
audio cord or coaxial digital cord*. You can enjoy the DVD's Dolby
Surround sound.
* If you connect a coaxial digital cord, you cannot use the TVS function of this
player.
Before operating this player, adjust the settings of this player ("DIGITAL
OUT"/"DOLBY DIGITAL"/"DTS"/"MPEG") according to the connected
components (e.g., amplifier). For details, see "Settings and Adjustments"
TV
on the Blue Side of this manual.
I N P U T
Connecting an amplifier using a stereo audio cord
S V I D E O
White
Player
L ( w h i t e )
A U D I O
To VIDEO OUT
R ( r e d )
VIDEO OUT
Red
S-VIDEO OUT AUDIO OUT
DIGITAL OUT(COAXIAL)
To AUDIO OUT L/R
Connecting an amplifier using a coaxial digital cord
Player
(volume) control
To VIDEO OUT
VIDEO OUT
AUDIO OUT
S-VIDEO OUT
DIGITAL OUT(COAXIAL)
To DIGITAL OUT
(COAXIAL)
Note
When you use the DIGITAL OUT (COAXIAL) jack to listen to MPEG audio signals
and set "MPEG" to "MPEG" in "AUDIO SETUP," no sound will come from your
speakers if you select one of the TVS modes.
To video input
TV
Audio/video cord
(supplied)
I N P U T
Yellow
Yellow
White I N P U T
White
To audio
(R)
input
(L)
Stereo audio cord
(not supplied)
Red
Red
Amplifier
To video input
TV
I N P U T
Audio/video cord
(supplied)
Yellow
To coaxial digital
Yellow
input
Coaxial digital cord
Amplifier
(not supplied)
Precautions
The power requirements, power consumption, and
region code of this player are indicated at the bottom
of the player. Check that the player's operating
voltage is identical with your local power supply.
Region code
X
DVP-XXXX
Power requirements and
00V 00Hz
00W power consumption
NO.
0-000-000-00
On safety
• Caution – The use of optical instruments with this
product will increase eye hazard.
• Should any solid object or liquid fall into the
cabinet, unplug the player and have it checked by
qualified personnel before operating it any further.
On power sources (mains)
• The player is not disconnected from the AC power
V I D E O
source (mains) as long as it is connected to the wall
outlet, even if the player itself has been turned off.
• If you are not going to use the player for a long
time, be sure to disconnect the player from the wall
L ( w h i t e )
outlet. To disconnect the AC power cord (mains
A U D I O
lead), grasp the plug itself; never pull the cord.
R ( r e d )
On placement
• Do not install the player in an inclined position. It
is designed to be operated only in a horizontal
position.
• Place the player in a location with adequate
ventilation to prevent heat build-up in the player.
• Do not place the player on a soft surface such as a
rug that might block the ventilation holes.
V I D E O
• Do not place the player in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust, or mechanical shock.
• Keep the player and discs away from equipment
DIGITAL IN
COAXIAL
with strong magnets, such as microwave ovens, or
large loudspeakers.
On operation
• If the player is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lenses inside the
player. Should this occur, the player may not