Attaching/Removing Vpll-Z1024/ Z1032 - Sony VPL-FH36 Operating Instructions Manual

Attaching/Removing VPLL-
Z1024/Z1032
Attaching the projection lens
adapter to the projection lens
Before starting
Since you may not recognize the center
position of the projection lens after the
flange section of the lens (step
place a mark on the projection lens with a
marking pen, etc.
1
Place the projection lens with the
motor section upward and place a
mark around the top screw hole on the
lens.
Motor section
Flange
section
2
Remove the six screws that secure the
flange section then slide it straight to
remove.
Notes
• The screws that secure the flange section
are strongly tightened. When removing
the screws, be careful not to damage the
screw heads.
48
Removing/Attaching the Projection Lens
) is removed,
1
Top screw
Mark
Screws (6)
Spacer
• When the flange section is removed, the
spacer section is also loosened. Be
careful that the spacer section is not
removed.
3
Insert Part C for the lens adapter all the
way until it is securely in place, align the
mark with the mark placed in step 1,
then tighten the six D screws supplied
with the lens adapter.
D screws (6)
Mark placed in step 1
Part C for the lens
adapter
4
Attach Part A and Part B for the lens
adapter to the projection lens.
1 Remove the lens cap.
2 First, fit Part A to the zoom gear
section on the projection lens.
3 Fit the holes on Part B to the hooks
on Part A then hold the projection
lens between Part A and Part B for
the lens adapter.
2
Zoom gear section
Mark
3
Part A for the
lens adapter
Part B for the
lens adapter