3
Hold the projection lens with the
removable lever at an angle of 45
degrees to the right side, and insert the
lens into the main unit, fitting the
protrusions into the grooves of the
adapter.
Groove of
the adapter
Spring
Projection lens
Note
Do not touch the springs of the projection
lens.
4
Attach the projection lens by rotating
it clockwise until the lens is fixed.
Notes
• Check that the removable lever is in the
position as illustrated above.
• After attaching the projection lens, do
not place the projector upside down.
When the lens is attached, perform the focus
adjustment (page 46).
Removable lever
Protrusion
Removable lever
Removing
1
Rotate the removable lever of the
projection lens counterclockwise and
rotate the projection lens
counterclockwise.
2
Pull out the projection lens straight.
Projection lens
Note
Do not touch the springs of the projection
lens.
3
Loosen the two screws that secure the
front panel to remove the front panel
in the frontal direction.
Removing/Attaching the Projection Lens
Removable lever
45