Table of Contents
Advertisement
---
Maintenance
Belt or brush removal and replacement
1
Grasp brushroll with one hand,
using the other hand to keep tension
on the the belt while removing.
Belt or brush removal and replacement
1
When replacing the belt first slide it
onto the motor shaft. Then slip the
brush roll through the belt. Place the belt
in the area of the brush without bristles.
Slide the brush roll into the nozzle,
ensuring that the brush roll end caps are
orientated correctly, see inset picture.
Manually turn the brush roll to
check that it is fitted properly.
8
(Keep your Dirt Devil as good as new)
2
Lift up while your pulling it out.
Phillips screwdriver required
2
Replace the belt cover by inserting
the end furthest from the brush first.
Then replace the front of the belt
cover before securing in place with
the two screws.
AU: 1300 361 505 / NZ: 0800 800 900
3
Slide the belt off the the motor
shaft and dispose.
Dirt Devil Service line
Advertisement
Table of Contents
