Operation - Dirt Devil DDCW600 User Manual

---

Operation

Putting your cleaner together
1
Stand the base in the upright
position. Assemble the mid section
onto the base, taking care not to
trap internal mains wire.
How to opereate your cleaner
1
Important: Turn off when emptying
and filling the reservoir.
Grasp the solution reservoir under
the handle and press the release
lever upward.
4
Phillips screwdriver required
2
Insert the three nuts into the
recesses located on the left and
right sides and the middle of the
back of the base.
While holding the nuts in place
insert screws through the front of
the mid section and tighten.
2
Tilt the solution reservoir away
from the cleaner and remove.
AU: 1300 361 505 / NZ: 0800 800 900
3
Slide upper handle down onto the
unit. Insert nut into the recess in
the back of the upper handle.
While holding the nut in place
insert the screw through the front
of the upper handle and tighten.
Run the mains cable above the
upper cord hook and secure with
the cord clip.
3
Unscrew the filler/ measuring cap
from the rear of the solution
reservoir.
Note: Always use the
filler/measuring cap from the
reservoir to determine precise
solution quantity.
Dirt Devil Service line