Table of Contents
Advertisement
7 – Internal Settings
PARALLEL connector settings
Use the
PARALLEL INPUT
pages to make parallel connector input and output settings.
PARALLEL INPUT page settings
INPUT AUX1 – INPUT AUX6
8
This shows the current functions set for INPUT AUX1 – INPUT
AUX6 of the PARALLEL connector.
Select
–
INPUT AUX1
INPUT AUX6
JOG dial to open the
PARALLEL INPUT
When
INPUT AUX1
–
INPUT AUX1
INPUT AUX6
Set the functions for INPUT AUX1 – AUX6 of the
PARALLEL connector.
Options:
PLAY/PAUSE
(default for INPUT AUX6)
PAUSE
REC
(default for INPUT AUX3)
FADER REC
FADER START
(default for INPUT AUX4)
REW
(default for INPUT AUX5)
F.FWD
(default for INPUT AUX2)
TAKE SKIP -
(default for INPUT AUX1)
TAKE SKIP +
MARK SKIP -
MARK SKIP +
TAKE/MARK SKIP -
TAKE/MARK SKIP +
MARK
NOTE
• Setting multiple FADER REC and FADER START settings to
INPUT AUX is not possible.
• When set to FADER REC, low signal input starts recording
and high signal input stops recording.
• When set to FADER START, low signal input starts playback
and high signal input pauses playback.
• When set to anything other than the above, it operates with
low signal input of 50 msec or longer. (See "Note about the
PARALLEL connector" on page 12.)
38
TASCAM DA-6400/DA-6400dp
and
PARALLEL OUTPUT
, and press the MULTI
screen.
selected
items
PARALLEL OUTPUT page settings
OUTPUT AUX1 – OUTPUT AUX5
8
This shows the current functions set for OUTPUT AUX1 –
OUTPUT AUX5 of the PARALLEL connector.
Select
–
OUTPUT AUX1
OUTPUT AUX5
MULTI JOG dial to open the
PARALLEL OUTPUT
When
OUTPUT AUX1
–
OUTPUT AUX1
OUTPUT AUX5
Set the functions for OUTPUT AUX1 – AUX5 of the
PARALLEL connector.
Options:
(default for OUTPUT AUX1)
STOP TALLY
(default for OUTPUT AUX4)
PLAY TALLY
(default for OUTPUT AUX5)
PAUSE TALLY
(default for OUTPUT AUX2)
REC TALLY
EOM TALLY
(default for OUTPUT AUX3)
ERROR TALLY
EOM/ERROR TLLY
NOTE
When the INFO indicator is lit red, an ERROR TALLY signal is
being output.
EOM
8
This shows the setting status of the EOM (End Of Message)
function.
If the available recording time (when recording or in recording
standby) or the total remaining playback time (when playing
back or in playback standby) becomes less than the set time,
an EOM tally signal will be output from the pin number of the
PARALLEL connector that corresponds to any
–
item set to
OUTPUT AUX5
.
TLLY
item, and press the MULTI JOG dial to open the
Select the
EOM
screen.
EOM
item
TIME
Set the amount of time that will cause an EOM tally
signal to be output.
Options:
(default),
OFF
ments)
, and press the
screen.
selected
items
OUTPUT AUX1
or
EOM TALLY
EOM/ERROR
–
(1sec incre-
1sec
99sec
Advertisement
Table of Contents
