Table of Contents
Advertisement
Disassembly
22
3.
Insert the disassembly tool between the front and rear housings and rotate it
at the places indicated (as shown in Figure 9) to release the housing snaps.
Press on the front housing and then pull the front and rear housings apart.
Figure 9. Removing the Rear Housing Latches
4.
Lift the top end of the rear housing, and then the bottom end away from the
phone.
5.
To replace, align the rear housing to the phone.
6.
Carefully press the rear housing onto the phone until all the housing snaps are
fully engaged.
7.
Insert 6 T6 screws into the rear housing assembly and tighten to 14 Ncm
(1.25 inch-pounds).
8.
Replace the battery and battery door as described in the procedures.
May 15, 2006
3
Rear housing
4
4
Disassembly tool
Q CDMA
2
1
4
6809495A97-O
060195o
Advertisement
Table of Contents
