Introductory Information; Commissioning; Terminology; Your System Is Preset At The Factory - Viessmann VITODENS 100-W Operating Instructions Manual

Introductory information

Commissioning

The commissioning and adjusting of the
control unit to local conditions and to
building characteristics, plus the instruc-
tion of the user in operating the system,
must be carried out by your heating con-
tractor.
g Gas council no.
Rated heating output range
kW
6.5 - 19
6.5 - 26
8.8 - 30
8.8 - 35

Terminology

To provide you with a better understand-
ing of the functions of your Viessmann
control unit some terminology is
explained.
The terms are marked as follows:

Your system is preset at the factory

Your heating system is preset at the fac-
tory and is therefore ready for opera-
tion.
Your heating contractor can make fur-
ther settings for you during commission-
ing.
6
As the user of new combustion equip-
ment, you may be obliged to notify your
local flue gas inspector of the installation
[check local regulations]. Local flue gas
inspectors will also inform you [where
appropriate] about work they may be
required to perform on your combustion
equipment (e.g. regular checks, clean-
ing).
Gas condensing boil-
er
41-819-26
41-819-27
41-819-28
41-819-29
You can change the settings individually
at any time to suit your requirements.
Power failure
All settings are saved if there is a power
failure.
Gas condensing combi
boiler
—
47-819-20
47-819-21
47-819-22
Further information can be found
in chapter "Terminology" in the Ap-
pendix.