Sunbeam Cafe Series EM7100 Instruction/Recipe Booklet page 16

Advanced Programming continued
Espresso Thermoblock Temperature
The temperature of the thermoblock has been
calibrated to 92°C. However the coffee maker
can adjust the temperature of the espresso
thermoblock in increments of 2°C up and
down, should it be desired.
1. Ensure the espresso machine is plugged in
and switch on at the power outlet.
Note: DO NOT press the POWER button on
the espresso machine.
2. PRESS and hold down the 1 CUP button.
3. While still holding down the 1 CUP button
briefly PRESS the POWER button and then
release the 1 CUP button.
To indicate you have activated the
programmability of the espresso thermoblock
temperature, a light on one of the buttons
will illuminate;
1 CUP = Factory setting
2 CUP = +2°C
CAPSULE = +4°C
MANUAL = -2°C
POWER = -4°C
This light will remain on for up to 5 seconds
before automatically returning to factory
settings if no action is taken. The espresso
machine will then power on.
-4ºC -2ºC
14
Factory
+2ºC +4ºC
Setting
4. PRESS and RELEASE one of the buttons
below depending on the required
temperature adjustment;
+2°C = PRESS the 2 CUP button
+4°C = PRESS the CAPSULE button
-2°C = PRESS the MANUAL button
-4°C = PRESS the POWER button
When the new temperature setting has been
selected the espresso machine will beep
twice.
5. The espresso machine will then
automatically power on.
Steam Thermoblock Temperature
The temperature of the steam thermoblock
has been calibrated to deliver a powerful,
constant supply of dry steam for texturing
milk. The temperature of the steam can be
modified in increments. of 5°C up and down
should it be desired.
1. Ensure the espresso machine is plugged in
and switch on at the power outlet.
Note: DO NOT press the POWER button on
the espresso machine.
2. PRESS and hold down the 2 CUP button.
3. While still holding down the 2 CUP button
briefly PRESS the POWER button and then
release the 2 CUP button.
To indicate you have activated the
programmability of the steam thermoblock
temperature, a light on one of the buttons
will illuminate;
1 CUP = Factory setting
2 CUP = +5°C
CAPSULE = +10°C
MANUAL = -5°C
POWER = -10°C