Platen Cover, Flushing Foam L1 And L2 - Brother MP-21C Service Manual

<Reassembly>
(1) Fit the Bearing L in the Chassis L.
(2) Insert the left end of the Paper eject roller ASSY into the Bearing L. Fit the Bearing
R to the right end of the Paper eject roller ASSY. Insert the right end of the
Bearing R into the Chassis R.
(3) Turn the Bearings L and R until the Paper eject roller ASSY is secured.
4.9.6

Platen Cover, Flushing Foam L1 and L2

<Disassembly>
(1) Remove the Paper eject sensor actuator from the Platen cover, taking care not to
damage the two hooks holding the actuator.
Caution: Use caution when handling the thin, metal actuator; its sharp edges may
hurt you.
Note: DO NOT bend the Paper eject sensor actuator; it is thin and care is needed
to avoid damaging this part
<Reassembly>
Note: Attach the Paper eject sensor actuator to the Platen cover so that the
protrusion at the end of the Paper eject sensor actuator fits in the notch of
the Platen cover.
Paper eject sensor actuator
Hook
Fig. 3.36
III-26
Platen cover