Table of Contents
Advertisement
Introduction
Connectors
CFP
8
CIR
CSPK
SATA1 ~ SATA6
9
or
SATA1 ~ SATA4
10
THM-ST
(Optional)
CP80P
11
12
LEDION
13
EZ-Button
12
Figure
Descriptions
CFP: Case Front Panel Connector
CIR: IR connector
For connection to an IrDA receiver unit.
CSPK: Speaker
Connects to the case's speaker for PC beeps.
SATA1 ~ SATA6: Six Serial ATA II Connectors from nF570, or
1
SATA1 ~ SATA4: Four Serial ATA II Connectors from nF550
GND
B+
B-
A-
A+
GND
These connectors enable you to connect Serial ATA HDDs or
GND
optical drives type.
Thermo Stick:
Flexible thermometer to let you measure any temperature by
software. Ideal for monitoring VGA card, chipset or even disk
drives temperatures.
CP80P: Post Port Debug LED
Provides two-digit POST code to show why the system fail to
boot. Allows quick and easy optimization.
The LED will display the CPU temperature when you run the
bundled Thunder Probe software.
LEDION:
Onboard LED indicators to show the power status of CPU,
Chipset and DRAM. You know immediately where to look if the
system fails to start.
EZ-Button — RESET, PW-ON:
These onboard buttons lets you turn on/off the system easily,
it is especially handy for debugging or testing the system.
The LED on PW-ON button shows the power status, the LED
on RESET button shows the HDD status.
HD_LED
This LED indicates hard drive activity.
PWR_LED
Connects to the power indicator on the PC case.
RST
Connects to the RESET switch on the PC case.
PW_ON
Connects to the Power button on the PC case, to turn on
the system. To turn off the system, press the power
button for 4 seconds.
Advertisement
Table of Contents
