Operation Mode - Planet FRT-405N User Manual

300mbps 802.11n wireless internet fiber router

Hide thumbs Also See for FRT-405N:

Table of Contents

User Manual of FRT-405N

5.1 Operation Mode

The FRT-405N supports three operation modes – Bridge, Gateway and WISP. Currently, the default setting is

Gateway mode.

Please note that Bridge mode and Gateway mode cannot be used simultaneously.

For Bridge mode, all interfaces are bridged into a single bridge interface.

For Gateway mode, the fiber port is treated as WAN port. The other interfaces are bridged together and are

treated as LAN ports.

For WISP Mode, all the Ethernet ports (including fiber port) are bridged together and the wireless interface of

this router will come to WAN port for connecting to an ISP's Access Point as Internet connection. The NAT is

enabled and PCs in Ethernet ports share the same IP to ISP through wireless LAN. The connection type can

be set up on WAN page by using PPPoE, DHCP client, PPTP/L2TP client or static IP.

If you select Bridge mode and WAN configuration in Internet Settings that are not

available, firewall functions on the left page are not available, either.

After finishing the settings, click Apply to save the settings and enable the new configuration to take effect.

Click Cancel to close without saving.

Table of Contents