Removing Or Installing A Rear Drive; Removal - IBM 7013 J Series Operator's Manual

Removing or Installing a Rear Drive

This procedure is for the disk drives installed in the rear drive positions on the base unit and
expansion unit.
Attention: Do not operate the system unit with the covers removed for a long time.
Operating with the covers on ensures adequate cooling of the components. Remove the
covers only when required by the removal and installation procedures.

Removal

1. Use the "Unconfiguring" procedure on page 4-7 to remove the drive from the system
configuration. See "Locating a Disk or Media Drive" on page 4-4 for drive locations.
2. Turn the rear cover key clockwise to unlock the rear cover. The rear cover key is the
same as the one used on the operator panel.
3. With a firm grip on the cover, tilt it towards you and upward as shown, to remove it from
the unit.
4-10
Operator Guide