Table of Contents
Advertisement
Installing the rear hard disk drive cage assembly
To install the rear hard disk drive cage assembly, complete the following steps.
Rear hard disk
drive cage
Retention latch
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If you removed a hard disk drive, reinstall it (see "Installing the rear hard disk
3. Insert the drive-cage assembly into the server; then, slide the drive-cage
4. Close the drive-cage assembly retention latch.
5. Install the cover (see "Installing the cover" on page 31).
6. Slide the server into the rack.
7. Reconnect the power cords and any cables that you removed.
8. Turn on the peripheral devices and the server.
Removing the front hard disk drive
Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this chapter.
To remove the front hard disk drive, complete the following steps.
56
IBM System x3455 Type 7940 and 7941: Problem Determination and Service Guide
on page 29.
drive" on page 59).
assembly toward the rear of the server until it seats securely.
Advertisement
Table of Contents
