Pairing With Your Device - Dual XGPS190 Owner's Manual

XGPS190

Pairing with your device

The instructions below will guide you through
the initial pairing process which connects the
XGPS190 to your tablet/smart phone. Once the
XGPS190 is paired with your device, it is ready
to use.
The XGPS190 can pair to two devices at a time.
To pair to the second device, repeat the same in-
structions you followed for the first.
When powered on subsequently, the XGPS190
will automatically try to reconnect to the last
tablet(s) it was paired with. Keep this in mind when
trying to use it with multiple devices: if you are hav-
ing trouble getting another device to recognize the
XGPS190, make sure the last device you used
with the XGPS190 is turned completely off or is
out of Bluetooth range.
If the Bluetooth connection is interrupted while
communicating, either because a device is turned
off or because the distance between the two de-
vices is too great, you must turn the XGPS190 off
and back on in order for it to automatically recon-
nect. Alternatively, you can go into your device's
settings menu and manually reactivate the link.
NOTE: Activating Airplane Mode on the iPad/
iPhone/iPod (which is recommended when flying)
automatically turns off Bluetooth, so it must be
10
manually turned back on. The recommended
procedure with the iPad/iPhone/iPod is to activate
Airplane Mode, turn Bluetooth back on and then
turn on the XGPS190.
NOTE: The battery in the XGPS190 is already
partially charged and the device should turn on
the first time you take it out of the box. If the
device does not turn on, please charge it from a
USB source before continuing - see Charging on
page 15.
NOTE: If your device requests a code to con-
nect during the pairing process, use "0000" or
"1234".
Pairing the XGPS190 with the iPad, iPod touch
or iPhone
(NOTE: these instructions were written using iOS
version 9.0 and may be different if you are using a
different version of the iPhone OS.)
• Turn on the XGPS190. The blue Bluetooth
status light on the XGPS190 will start blinking
slowly (about once per second).
• On the iPad/iPod touch/iPhone, go to:
Settings->Bluetooth
and turn on Bluetooth. The device will automati-
cally begin looking for the XGPS190.
• After a few moments, the XGPS190 will ap-
XGPS190
11