Dual XGPS190 Owner's Manual page 5

XGPS190
Setup
Step 1) Remove the rubber cap on the front side
of the XGPS190 to expose the antenna connector.
Attach the included ADS-B antenna, or connect an
external non-amplified antenna using a high qual-
ity shielded coaxial cable.
Step 2) Pair the XGPS190 to your iPad or Android
tablet (see Pairing with your device below). The
XGPS190 will work with up to two devices simul-
taneously.
Step 3) Position the XGPS190 on the glare shield
or affix it to a window using the included non-slip
pad.
Step 4) Download the free ADS-B Status Tool
app from the iTunes App store. This app will give
you information about your XGPS190, such as
battery level, charging status and GPS reception
status.
PLEASE NOTE: The XGPS190 is intended to be
used with popular EFB apps. A current list of com-
patible EFB apps is available on the web at http://
XGPS190.dualav.com.
Step 5) Open a compatible EFB app and begin
using the XGPS190.
8
Non-slip pad
The included non-slip pad is designed to hold the
XGPS190 securely in place on most surfaces.
With the open edge of the pad facing toward you,
insert the XGPS190 into the pad so that the red
dot will be on the left side.
If the bottom of the pad looses its stickiness from
an accumulation of dirt/dust, simply wash the pad
with warm water and a mild soap and allow the
pad to air dry.
Important note about heat
The XGPS190 has been designed to work at high
temperatures, and it is normal for the XGPS190 to
become warm when operating. It will also absorb
additional heat from the direct sun or when sitting
on a hot glare shield so please use caution when
handling the XGPS190 after it has been run-
ning in the direct sun because it may be hot.
XGPS190
9