Matrox Monarch HDX User Manual page 29

Switch to Static IP mode
You can switch your Monarch HDX device to Static IP mode by pressing the
ENCD 2 button while the Encoder 2 LED flashes during the power-up sequence.
Press the Reset button on the device to initiate a device reboot. During the
1
power-up sequence (see
Encoder 2 LED flashes for three seconds.
2 Press the ENCD 2 button on the device while the Encoder 2 LED is flashing.
This sets the device to Static IP mode and the Static IP address to its default
address (169.254.1.11).
The device is ready when the Warning (
Warning LED ( ) may remain on if there is an error condition (see
page" on page 23 for more information).
Reset to factory defaults
When resetting Monarch HDX using this method, all Monarch HDX settings
reset to factory defaults, the device password resets to admin, and the device
powers up in DHCP IP mode for connecting to a network with a DHCP server,
such as a router. To switch the device to Static IP mode after performing a factory
reset, see "Switch to Static IP mode"
To reset Monarch HDX to factory defaults, press and hold the Reset button on the
device for at least five seconds. The device begins a power-up sequence during
which various LEDs will flash on and off. The Warning (
flash early during the boot up sequence, and once it stops flashing, the Monarch
HDX is ready for use.
The Warning LED (
page" on page 23 for more information.
"Powering Monarch HDX"
) LED stops flashing; however, the
on page 13.
) may remain on if there is an error condition (see
on page 11), the
) LED will begin to
Matrox Monarch HDX hardware
13
"Status
"Status