Remote Ac Control Hookups - Monster Power HTS 5000 Owner's Manual

STEP 3

Remote AC Control Hookups

NOTE:
This feature allows you to turn on/off your PowerCenter via your A/V receiver or preamplifier. You can't turn off the
PowerCenter using the front panel OFF button when the NORMAL/REMOTE switch is switched to REMOTE.
A) Plug the Remote AC Control cable's (included) female end into back of your PowerCenter (see diagram below).
B) Switch the NORMAL/REMOTE switch (located on the back of the PowerCenter) to REMOTE.
C) Press the OFF button to turn off the PowerCenter.
D) Plug the Remote AC Control Cable's 2-prong male end into a switched AC power outlet on a receiver
or preamplifier. When you turn on your receiver or preamplifier the PowerCenter's outlets programmed
as "switched on" will be turned on immediately. However, the PowerCenter's outlets programmed as
"switched on after delay" will be turned on after a delay set by the DELAY TIME switch.
1 2
GROUND
9
IN
IN
3 4 5
IN
CABLE TV NORMAL
OUT
OUTLET PROGRAMMING SWITCHES
REMOTE
UNSWITCHED SWITCHED DELAY NO DELAY
1 IN
2
SATELLITE REMOTE
3
OUT PHONE
AC IN
110V
4
0.3A
5
DELAY
TIME
SHORT LONG
SWITCH
(6 seconds) (20 seconds)
ANTENNA DELAY NO DELAY TRIGGER
DC IN
OUT
OUT
3~30V
DC OUT SWITCH
9~12V
300MA
BREAKER 15A
PRESS TO RESET
OUT 1
OUT 2
1800W MAX TOTAL