Table of Contents
Advertisement
OPERATING INSTRUCTIONS
1. STOP! Read the safety information label.
2. Make sure the manual shutoff valve is fully open.
3. This gas log set is equipped with an ignition device (piezo) which automatically lights the pilot. If piezo
ignitor does not light the pilot, See instructions for Match Lighting Instructions, page 32.
4. Turn gas control knob clockwise
ON/OFF switch to OFF position.
5. Wait (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP!
Follow "B" in the safety information label. If you don't smell gas, go to next step.
6. From OFF position, turn the gas control knob counterclockwise
knob for 5 seconds.
7. With the control knob pushed in, push in and release the piezo ignitor button to light the pilot.
8. Continue pushing the control knob in for a further 60 seconds to prevent the flame detector from shutting off
the gas while the probe is warming up. Release the control knob.
9. Turn gas control knob counterclockwise
10. After the pilot has been lit for one minute, the burners can be turned on. Turn the ON/OFF switch to ON
position or adjust thermostat to desired setting.
11. If the gas logs will not operate, follow the instructions To Turn Off Gas To Appliance below and call your
service technician or gas supplier.
Figure 49 - Pilot
1. Turn control knob clockwise
2. If applicable: Turn ON/OFF switch to OFF position and/or set thermostat (if present) to lowest setting.
3. If applicable: Turn off all electric power to the heater.
32
MILLI-VOLT CONTROL LIGHTING INSTRUCTIONS
to the OFF position, set the thermostat to the lowest setting and turn
Wait 30 seconds before readjusting the
heater when the control knob has been
turned down to a lower setting.
Figure 50 - Control Knobs
TO TURN OFF GAS TO HEATER
to OFF position to completely shut off the heater.
to the ON position.
to IGN position. Push in control
Figure 51 - Piezo
33D4047
Hide quick links:
Advertisement
Table of Contents
