Removing And Replacing Airflow Guides - HP 9000 rp3410 User's & Service Manual

Installing the System
Installing Additional Components
Installing the DVD Drive
To install a DVD drive, follow these steps:
Step 1. Power off the server and disconnect power and external cables.
Step 2. Remove the front bezel and cover. (See "Removing and Replacing Server Covers and Bezels" on
page 63.)
Step 3. If a removable media drive has not previously been installed in the server, the drive slot will be
covered with a DVD drive filler. Remove the DVD drive filler.
Step 4. Slide the drive into the drive bay until it stops sliding and the retaining clips on both sides of the
drive snap into place (Figure 3-22).
Step 5. Connect the IDE cable on the back of the drive (Figure 3-22).
Step 6. Replace the cover and bezel. (See "Removing and Replacing Server Covers and Bezels" on page 63.)
Step 7. Reconnect the power and external cables and turn on the server.
Step 8. Verify the drive operation by using the system utilities.
• Use the iLO MP commands to verify operation.
• Use the BCH commands to verify operation.
• Use diagnostics provided by the offline diagnostic environment to exercise the newly installed
module.

Removing and Replacing Airflow Guides

You must remove airflow guides before installing processors or memory. The server has the following airflow
guides:
• The processor airflow guide ensures that the proper volume of air for cooling the dual processor module
power pods, processor modules, and voltage regulator modules flows over these components. You must
remove the processor airflow guide before removing or installing a dual processor module.
• The memory airflow guide ensures that the proper volume of air flows over the memory DIMMs to cool
them. You must remove the memory airflow guide to access memory DIMMs and sockets.
Air flows through the server from front to back.
NOTE
78
Chapter 3